Search Results

You searched for "roof"

7 FAQs Found Page 1 of 1
	We are using a Dryvit system in Augusta, Ga. I have located attachment paterns with Winlock fasteners in your e-lit, however it only gives details for EPS up to 2". As you will see in the next paragraph, we are using thicker EPS with Hilti fasteners. Please provide a recommended pattern as such. The design wind speed at this building is 100 mph. The worst case wall component and cladding wind pressure (10 ft2 area) is 25 psf. The assembly is as follows: 18" cast in place concrete wall, Tremco 250 Water proofing cured (60mils - self sealing), Mechanically fasten EPS with Hilti X-IE Insulation Fastener 4” 6-100 PH 52 No. 376475. Complete the Dryvit (hole patch, base cait, finish, etc.) per manufature's recommendations.
	How is a Drainage Strip installed in an area with a membrane roof without doing any perforations?
	Is flashing required with EIFS?
	Hello , I have a customer that has woodpeckers making many holes in her home. even though we have repaired those areas the woodpeckers just keep coming back and making more holes in the dryvit. She is asking if there is a skim coat or product that can be used to make the dryvit more bird proof. All I could think of is some sort of masonry application over the dryvit but I dont't know how all that would work out, I know I definately dont't want to put a warranty on it. Any help you have on this would be greatly appreciated.
	I am planning on replacing replacing my roof. I have two walls that are covered with dryvit and butt up against the roof. What is the proper way of replacing the flashing on these roof/wall sections? I had several contractors tell me different approaches and need to know the recommend procedure. EIFS
	How often are expansion joints required?
	What is a “Roof Stop” flashing? Where is it installed?
Go to Page : 1

Can't Find an Answer? If you cannot find an answer to your question, you can submit it to us and receive an answer by e-mail.